Weber Tylon Rapid 12
Weber Tylon Rapid 12
20 kg
12 hour set adhesive for all types of tiles
Weber Tylon Rapid 12 is a cement-based, high strength bed tile adhesive that can be applied in bed thicknesses between 3 - 6 mm and up to 12 mm in isolated areas only (non-continuous) for the fixing of Porcelain, Ceramic, Clay, Brick, Cement, and Natural Stone tiles to walls and floors. Produced from carefully selected raw materials for consistency of product, it only requires the addition of water on site.
SUITABLE SURFACES
Weber Tylon® Rapid 12 Is suitable to use on surfaces like:
• Pre-cast concrete
• Post tensioned floors
• Heatedscreed
• Tile on tile applications
• Power-floated floors
C2F EN Classification
Depending on the nature and evenness of the surface and method of application, approximately 6 m² per 20 kg bag when applied using a 6 mm notched trowel (wall tiling) and 4 m² per 20 kg bag when applied when using a 10 mm notched trowel (floor tiling) ie: based on a level/even floor.
| Classification | C2F |
| Initial setting time | approximately 4 hours |
| Final setting time | approximately 12 hours |
| Correction time | approximately 20 minutes |
| Open time | approximately 20 minutes |
| Pot life | approximately 2 hour |
| Grouting time | approximately 12 hour |
| Water demand | approximately 5 litres per 20 kg |
| Temperature resistance | 70 °C |
| Application temperatures Note: all the data given was obtained at a temperature of 23 °C and 50% relative humidity. Rapid 12 is designed to meet the following SANS 52004 related performance values. | Do not apply in temperatures below 5 °C or above 30 °C |
| Initial tensile strength | > 1.0 N/mm² |
| Tensile adhesion strength after heat aging | > 1.0 N/mm² |
| Tensile adhesion strength after water immersion | > 1.0 N/mm² |
| Open time: tensile adhesion strength (after no less than 20 min) | > 0.5 N/mm² |
- 12-hour set
- Interior and exterior application
- Can be applied up to 20 mm thick
- Anti-slip properties
- Suitable for wall and floor use
- Consistent quality - ISO 9001 and 14001 accredited manufacturer
Weber Tylon® Rapid 12 is suitable for walls and floors, suitable for interior and exterior use.
Do not use this product on white or light coloured marble or porous porcelain tiles, as it might cause discolouration of the tiles. It is most suitable for levelling and repairing surfaces with depressions up to 8 mm before applying tiles. Weber White is recommended for this purpose.
